Aviation | Hazards | Winter Weather

hazard-winter

 

 

Winter Weather

Winter conditions are challenging to all aviation and include several hazardous phenomena: Icing (aloft and at ground level), snowfall, reduced visibility and inversion. These phenomena can occur simultaneously or separately, during taxiing, take-off, en-route and landing. Small aircraft, rotorcraft and remotely piloted aircraft systems (RPAS) are especially influenced by winter weather due to their small size, low flight altitude and propulsion system.

For aviation, icing is significant weather regardless of intensity and vertical location (at ground level or aloft). Icing can be from: freezing rain (FZRA), freezing drizzle (FRDZ) freezing fog (FZFG) and rime formation. See here.

Freezing rain and freezing drizzle are supercooled water freezing on impact to any surface. Ice accretion in freezing rain can be rapid and amounts can be significant. Ice build-up is hazardous to airframes, ground equipment (vehicles and radars) and other infrastructure (power lines etc.) Runway de-icing is also a significant challenge in freezing rain events. Ice as well as snow affects airplanes themselves and shall be removed before take-off during de-icing activity at airport.

In freezing fog, ice accretion is slower but visibility is seriously reduced, below 1000m.

Hoar frost formation occurs in clear, calm weather and is quite slow. Rime ice mostly influences buildings and other structures such as radar and instrument towers. Parked aircraft can be rimed if parked outside overnight or for longer periods. Hoar frost can occur in temperature inversion. This phenomenon with a severe intensity can cause runways to be iced, too.

Snowfall reduces visibility, clings to surfaces (especially moist snow) and prompts runway maintenance procedures. Any snow must be cleared from airframes before take-off. Although snowfall is routinely forecast, and rarely a challenging event, snowfall can present significant logistic challenges to airport management. Time between de-icing and take-off cannot exceed snow buildup time, usually 15 minutes. In such case aircraft must undergo a second de-icing procedure. De-icing requirement combined with runway clearance is a major challenge to airport management and can cause significant delays at airports experiencing few snowfall events. See here

Snow removal from runway is needed for safe landing. Photo Heikki Juntti (FMI) Photo Heikki Juntti (FMI)

Inversion where colder air is near the surface will prevent convection near the surface, and so will trap any particles (ice crystals, fog, smoke, etc.) near the surface leading to reduced visibility. Cold temperatures, below -20 C, induce ice crystal formation reducing visibility further. Cold air increases aircraft wing lift and in landing can lead to overshoot or overrun. Inversion can be accompanied with change in wind direction and speed.

These phenomena or combination of these phenomena cause adverse consequences: skidding off the runway due to low friction, ice/snow buildup on airframes and structures, aeroplane unable to land due to poor visibility and subsequent diversion to another airport.

De-icing of planes is essential during winter weather. Photo Heikki Juntti (FMI)

 

 

 

Photo Heikki Juntti (FMI) 

 

 

 

 

Airport operations are significantly influenced by winter weather. Snowfall can delay or stop airport operations in climates with irregular snowfall. For example, Madrid airport was closed two days (8-9 January 2021) due to snowstorm. Read more here.

Delays and congestion due to winter weather create indirect hazards and significant economic losses. Few studies are conducted on the psychological impacts of delays, cancelled flights and difficult operating environment due to winter weather conditions to the airport personnel and passengers and the associated costs of stress.

Forecasting these winter weather phenomena and their characteristics e.g. snow type, snow amount, with the accuracy required for efficient airport management operations requires high or very high spatial and/or temporal resolution numerical weather prediction (NWP) capabilities, often including ice phase physical processes. modelling.

Back to top


CLICK HERE to return to our homepage